330180-51-05前置控制器
統事件列表消息
以下系統事件列表消息可由機架接口模塊置于列表中，并按數字順序列出。如果發生標有星號（*）的事件…?提供消息的機架接口I/O模塊背面的主機鏈路將無法與主機通信?菊花鏈中的其他機架接口模塊仍能與主機通信？數據管理器I/O模塊的兩個端口將停止通信如果您無法解決任何問題，聯系最近的本特利內華達公司辦公室。閃存故障事件編號：11事件分類：潛在問題措施：盡快更換機架接口模塊。實時時鐘故障事件編號：12事件分類：嚴重/致命事件行動：立即更換機架接口模塊中的實時時鐘。內部網絡(luò )故障事件編號：30事件分類：嚴重/致命事件措施：立即更換機架接口模塊。重新同步內部網絡(luò )（重新同步內部網）事件編號：31事件分類：潛在問題措施：檢查以下組件之一是否有故障：?機架接口模塊?機架背板設備未通信事件編號：32事件分類：可能問題措施：檢查以下組件之一有故障：？模塊安裝在插槽中?機架背板6故障排除3500/20操作和維護42設備正在通信事件編號：33事件分類：潛在問題措施：檢查以下組件之一是否存在故障：?插槽中安裝的模塊?機架背背板配置令牌獲?。ㄅ渲昧钆偏@?。?/p>
事件編號：
50事件分類：典型的記錄事件特定事件：前、后、DM1（數據管理器端口1）、DM2（數據管理程序端口2）、ComGate（通信網關）指定端口可以下載配置、更改設置點、設置軟件開關、啟用/禁用機架報警抑制、啟用/停用跳閘倍增或執行機架復位。措施：無需采取任何措施。配置令牌釋放（配置令牌釋放）事件編號：51事件分類：典型記錄事件特定：前、后、DM1（數據管理器端口1）、DM2（數據管理端口2）、ComGate（通信網關）指定端口無法再下載配置、更改設定點、設置軟件開關、啟用/禁用機架報警抑制、啟用/停用跳閘倍增、，或執行機架復位。措施：無需采取任何措施。配置令牌過期（配置令牌過期）事件編號：52事件分類：潛在問題措施：檢查以下組件之一是否存在故障：?機架接口模塊與運行機架配置軟件的計算機之間的連接?機架接口模件?運行機架配置軟件的計算機配置令牌覆蓋（配置令牌覆蓋）事件編號：53事件分類：典型記錄事件操作：無需操作。
Statistics event list message
The following system event list messages can be placed in the list by the Rack Interface Module and listed in numerical order. If an event marked with an asterisk (*) occurs... ? The host link on the back of the Rack Interface I/O Module that provided the message will not be able to communicate with the host ? Other Rack Interface Modules in the daisy chain will still be able to communicate with the host? The two ports of the data manager I/O module will stop communicating. If you cannot solve any problems, contact the nearest Bentley Nevada office. Flash Failure Event Number: 11 Event Classification: Potential Problem Action: Replace the Rack Interface Module as soon as possible. Real time clock failure Event No.: 12 Event classification: critical/fatal event Action: Replace the real time clock in the Rack Interface Module immediately. Internal network failure Event No.: 30 Event classification: serious/fatal Event Action: Replace the Rack Interface Module immediately. Resynchronizing the internal network (resynchronizing the internal network) Event number: 31 Event classification: Potential problem Action: Check whether one of the following components is faulty: ? Rack interface module ? Rack backplane device does not communicate Event number: 32 Event classification: Possible problem Action: Check whether one of the following components is faulty:? The module is installed in the slot ? Rack backplane 6 troubleshooting 3500/20 operation and maintenance 42 Device is communicating Event number: 33 Event classification: Potential problem Action: Check whether one of the following components is faulty: ? Module installed in the slot ? Rack backplane configuration token acquisition (configuration token acquisition)
Event Number:
50 Event classification: typical recorded event specific events: front, rear, DM1 (data manager port 1), DM2 (data manager port 2), ComGate (communication gateway) specified ports can download configuration, change setpoints, set software switches, enable/disable rack alarm suppression, enable/disable trip multiplication, or perform rack reset. Action: No action is required. Configuration Token Release (Configuration Token Release) Event Number: 51 Event Classification: Typical recorded events Specific: Front, Rear, DM1 (Data Manager Port 1), DM2 (Data Management Port 2), ComGate (Communication Gateway) The specified ports can no longer download configurations, change setpoints, set software switches, enable/disable rack alarm suppression, enable/disable trip multiplication, or perform rack reset. Action: No action is required. Configuration Token Expiration (Configuration Token Expiration) Event Number: 52 Event Classification: Potential Problem Action: Check whether one of the following components is faulty: ? Connection between the Rack Interface Module and the computer running the Rack Configuration Software ? Rack Interface Module ? Computer running the Rack Configuration Software Configuration Token Override (Configuration Token Override) Event Number: 53 Event Classification: Typical Record Event Action: No Action Required.
