WOODWARD 9907-165調速器控制器
注意：VMIVME-7740需要強制空氣冷卻。建議在任何暴露的VMEbus插槽上安裝空白面板。這將允許VMIVME-7740板上的氣流更好。對于20插槽VME配置，建議使用三個100 CFM風扇。3.將VMIVME-7740及其連接的擴展模塊插入所選VMEbus機箱插槽（擴展模塊應填滿緊鄰VMIVME-7750的插槽）。在確保電路板在支撐電路板導軌中正確對齊和定向的同時，將電路板平穩地向前滑動抵靠配合連接器，直至牢固就位。4.將所有需要的外圍設備連接到前面板。每個連接器在前面板上都有清晰的標簽，詳細的引出線在附錄A中。如果用戶之前沒有配置過系統，則至少需要一個鍵盤和一個顯示器。5.接通系統電源。屏幕上顯示多條消息，包括VMIVME-7740上各種BIOS模塊的名稱、版本和版權日期
NOTE: The VMIVME-7740 requires forced air cooling. It is advisable to install blank panels over any exposed VMEbus slots. This will allow for better air flow over the VMIVME-7740 board. For 20-slot VME configurations, three 100 CFM fans are recommended. 3. Insert the VMIVME-7740 and its attached expansion modules into the chosen VMEbus chassis slot (expansion modules should fill the slots immediately adjacent to the VMIVME-7740). While ensuring that the boards are properly aligned and oriented in the supporting board guides, slide the boards smoothly forward against the mating connector until firmly seated. 4. Connect all needed peripherals to the front panel. Each connector is clearly labeled on the front panel, and detailed pinouts are in Appendix A. Minimally, a keyboard and a monitor are required if the user has not previously configured the system. 5. Apply power to the system. Several messages are displayed on the screen, including names, versions, and copyright dates for the various BIOS modules on the VMIVME-7740
