B&R 2DS100.60-1輸出模塊
電纜和連接器產品損壞模塊上的RJ-45連接器是雙絞線以太網（TPE）或E1/T1/J1網絡(luò )接口。將E1/T1/J1線路連接到以太網連接器可能會(huì )損壞系統。? 確保工作區域附近的TPE連接器明確標記為網絡(luò )連接器? 驗證連接到TPE套管的電纜長度不超過100米? 確保系統的TPE套管僅連接到安全超低電壓電路（SELV電路）。如果有疑問，請咨詢系統管理員。電池板/系統損壞鋰電池的錯誤更換可能導致危險爆炸。更換車載鋰電池時，確保新舊電池型號完全相同。如果沒有相應的電池型號，請聯系您當地的SMART EC銷售代表，以獲得官方認可的替代電池型號。數據丟失交換電池可能會(huì )導致時間設置丟失。備用電源可防止交換過程中數據丟失?？焖俑鼡Q電池可以節省時間設置。
Cabling and Connectors Product Damage RJ-45 connectors on modules are either twisted-pair Ethernet (TPE) or E1/T1/J1 network interfaces. Connecting an E1/T1/J1 line to an Ethernet connector may damage your system. ? Make sure that TPE connectors near your working area are clearly marked as network connectors ? Verify that the length of an electric cable connected to a TPE bushing does not exceed 100 meters ? Make sure the TPE bushing of the system is connected only to safety extra low voltage circuits (SELV circuits) If in doubt, ask your system administrator.Battery Board/System Damage Incorrect exchange of lithium batteries can result in a hazardous explosion. When exchanging the onboard lithium battery, make sure that the new and the old battery are exactly the same battery models. If the respective battery model is not available, contact your local SMART EC sales representative for the availability of alternative, officially approved battery models. Data Loss Exchanging the battery can result in loss of time settings. Backup power prevents the loss of data during exchange. Quickly replacing the battery may save time settings.
