EMERSON 1C31113G02模擬輸入模塊
從轉換模塊前面板上拆下PIM填充物。4.將無源互調模塊的面板（前擋板）從后面滑入前面板開口，并將無源互互調模塊放置在過渡模塊的頂部，與相應的兩個無源互調連接器對齊。然后，PIM模塊下側的兩個連接器應與轉換模塊上的相應連接器（J10和J14）平滑連接。5.將PIM附帶的四個短十字螺絲穿過轉換模塊底部的孔插入PIM前擋板和后支架。擰緊螺釘。有關正確的螺釘/板對齊，請參閱下圖。下面的示例可能無法準確地表示您的MVME7100。概述MOTLoad固件包用作板加電和初始化包，以及可以啟動用戶應用程序的車輛。
Remove the PIM filler from the front panel of the transition module. 4. Slide the face plate (front bezel) of the PIM module into the front panel opening from behind and place the PIM module on top of the transition module, aligned with the appropriate two PIM connectors. The two connectors on the underside of the PIM module should then connect smoothly with the corresponding connectors on the transition module (J10 and J14). 5. Insert the four short Phillips screws, provided with the PIM, through the holes on the bottom side of the transition module into the PIM front bezel and rear standoffs. Tighten the screws. Refer to the following figure for proper screw/board alignment. The example below may not accurately represent your MVME7100.Overview The MOTLoad firmware package serves as a board power-up and initialization package, as well as a vehicle from which user applications can be booted.
