EMERSON KJ1501X1-BK1模擬數字模塊
閃存磁盤將配置為出廠時的單個分區設備。下面的示例序列說明了創(chuàng )建兩個8MB分區的一種經過驗證的方法，其中一個作為活動主分區。請注意退出FDISK的說明。這已被證明是成功分區工作的重要一步。1.通電VMIVME-7750并進入CMOS設置。2.將IDE HDD Master設置為“未安裝”。將Flash Disk Master設置為“AUTO”（自動）。4.將引導設備設置為軟盤。5.從軟盤啟動DOS，并驗證系統配置屏幕是否僅顯示閃存磁盤。6.運行FDISK。7.刪除所有當前分區（當前存儲在分區中的任何數據都將丟失）。8.退出FDISK（這將導致重新啟動），然后再次運行FDISK。9.創(chuàng )建一個8M字節的主分區。10.創(chuàng )建一個8M字節的擴展分區。11.為8M字節擴展分區設置邏輯設備。12.將主分區設置為活動分區。13.退出FDISK
The Flash Disk will be configured as a single partition device as delivered from the
factory. The following sample sequence illustrates a proven method for creating two
8 Mbyte partitions, with one as an active primary partition. Take note of the
instructions to exit FDISK. This has been shown to be an important step in a
successful partitioning effort.
1. Power up the VMIVME-7750 and enter the CMOS set-up.
2. Set IDE HDD Master to “Not Installed”.3. Set Flash Disk Master to “AUTO”.
4. Set boot device to floppy.
5. Boot DOS from the floppy, and verify that the System Configuration Screen
shows only the Flash Disk.
6. Run FDISK.
7. Delete all current partitions (any data currently stored in the partitions will be
lost).
8. Exit FDISK (this will cause a reboot), then run FDISK again.
9. Create an 8 Mbyte primary partition.
10. Create an 8 Mbyte extended partition.
11. Set-up a logical device for the 8 Mbyte extended partition.
12. Set the Primary partition as an active partition.
13. Exit FDISK
