TRICONEX 4000093-110N控制系統配件
對固定IP地址使用以下設置：有關如何設置PC網絡(luò )連接的詳細信息，請參閱Windows有關配置TCP/IP的幫助。注意！如果電腦已經有來自另一個控制器或以太網設備的IP地址，則自動獲取IP地址可能會(huì )失敗。要確保在電腦之前連接到以太網設備時獲得正確的IP地址，請執行以下操作之一：?在連接到控制器之前重新啟動電腦。?將電腦連接到控制器后，從命令提示符運行命令ipconfig/renew。遠程網絡(luò )連接要啟用到遠程子網或本地網絡(luò )上的控制器的連接，必須允許相關網絡(luò )流量通過PC和控制器之間的任何防火墻。防火墻必須配置為接受從PC到控制器的以下TCP/IP流量：?UDP端口5514（單播）?TCP端口5515?被動FTP
Use the following settings for a fixed IP address:For detailed information about how to set up the PC network connection, see Windows help
on configuring TCP/IP.NOTE!
Obtaining an IP address automatically might fail if the PC already has an IP address from
another controller or Ethernet device.
To ensure that you get a correct IP address if the PC was previously connected to an Ethernet
device, do one of the following:
? Restart the PC before connecting to the controller.
? Run the command ipconfig /renew from the command prompt after connecting
the PC to the controller.
Remote network connection
To enable a connection to a controller on a remote subnet or over the local network, the
relevant network traffic must be allowed through any firewalls between the PC and the
controller.
The firewalls must be configured to accept the following TCP/IP traffic from the PC to the
controller:
? UDP port 5514 (unicast)
? TCP port 5515
? Passive FTP
