DEIF PPM-3/DGM DEIF模塊現貨
產品詳情資料：
DEIF PPM-3/DGM DEIF模塊現貨在存儲或裝運CPU期間維護RAM內存模塊化CPU模塊化CPU具有備用電池的內部連接器，以便在存儲或運輸CPU時保留RAM內存內容。當CPU模塊安裝在基板中且備用電池安裝在電源中時，不應使用這種布置。要在CPU模塊中使用備用電池，DEIF PPM-3/DGM必須卸下CPU模塊的前蓋。這可以通過以下步驟完成：為了避免CPU從PLC中取出后丟失內存內容，我們建議您在20分鐘內將備用電池安裝到CPU中。首先，確保PLC電源已關閉，然后卸下CPU模塊。輕輕擠壓CPU模塊的前蓋并將其向前拉，遠離模塊外殼，同時用小螺絲刀依次輕輕按壓4個前蓋卡舌。前蓋凸舌卡入模塊殼體兩側的孔中（前蓋固定凸舌的位置參見圖2-1DEIF PPM-3/DGM
DEIF PPM-3/DGMMaintaining RAM Memory During Storage or Shipment of a CPU Modular CPUs Modular CPUs have an internal connector for a backup battery so that RAM memory contents can be retained while the CPU is being stored or shipped. This arrangement should not to be used when the CPU module is installed in the baseplate and the backup battery is installed in the power supply. To use a backup battery in the CPU module, it is necessary to remove the front cover of the CPU module. This can be accomplished by following these steps:To avoid losing memory contents once the CPU is removed from the PLC, we recommend you install the backup battery into the CPU within 20 minutes. First, make sure PLC power is off, then remove the CPU module.Gently squeeze the front cover of the CPU module and pull it forward, away from the module case, while gently pressing in on the 4 front cover tabs sequentially with a small screwdriver. The front cover tabs latch into holes on each side of the module case (refer to Figure 2-1 for location of front cover holding tabs).DEIF PPM-3/DGM
品牌：DEIF
型號：DEIF PPM-3/DGM DEIF模塊現貨
產品說明：控制器
特點：模塊/卡件，控制器，觸摸屏，伺服驅動器
產 品 展 示
產 品 展 
公 司 主 營 優 勢
應 用 行 業
本篇文章出自瑞昌明盛自動化設備有限公司官網，轉載請附上此鏈接:http://www.fs-it.com.cn
