RELIANCE S-D4007-E數字量輸入卡件
1.產 品 介 紹
品牌：RELIANCE
型號說明：RELIANCE S-D4007-E數字量輸入卡件
優勢：供應進口原裝正品，專業停產配件。
公司主營特點：主營產品各種模塊/卡件，控制器，觸摸屏，伺服驅動器。
2.產 品 詳 情 資 料：
RELIANCE S-D4007-EEPROM/閃存周期時間EPROM/閃光周期時間可編程為3至10個總線時鐘/字節（4字節=12至40）。（實際循環時間可能會(huì )根據設備速度而變化。）數據傳輸為32位寬。請參閱RELIANCE S-D4007-E嵌入式控制器編程器參考指南。SCSI傳輸RELIANCE S-D4007-E嵌入式控制器包括一個帶DMA控制器的SCSI大容量存儲總線接口。SCSI DMA控制器使用FIFO緩沖器將8位SCSI總線連接到32位本地總線。FIFO緩沖器允許SCSI DMA控制器以四個長字脈沖串的形式將數據有效地傳輸到本地總線。這減少了SCSI設備對本地總線的使用。請參閱《MVME162FX嵌入式控制器程序員參考指南》中的MC2芯片編程模型。DMA控制器的傳輸速率為44MB/秒，32 MHz，奇偶校驗關閉，DRAM和讀周期交錯。假設SCSI總線上的連續傳輸速率為5MB/sec，則來自SCSI總線的傳輸將使用12%的本地總線帶寬。RELIANCE S-D4007-E
EPROM/Flash Cycle Times The EPROM/flash cycle time is programmable from 3 to 10 bus clocks/byte (4 bytes = 12 to 40). (The actual cycle time may vary depending on the device speed.) The data transfers are 32 bits wide. Refer to the RELIANCE S-D4007-E Embedded Controller Programmer’s Reference Guide.SCSI Transfers The RELIANCE S-D4007-EEmbedded Controller includes an SCSI mass storage bus interface with DMA controller. The SCSI DMA controller uses a FIFO buffer to interface the 8-bit SCSI bus to the 32-bit local bus. The FIFO buffer allows the SCSI DMA controller to efficiently transfer data to the local bus in four longword bursts. This reduces local bus usage by the SCSI device. Refer to the MC2chip Programming Model in the MVME162FX Embedded Controller Programmer’s Reference Guide. The transfer rate of the DMA controller is 44MB/sec at 32 MHz with parity off and interleaved DRAM and read cycles. Assuming a continuous transfer rate of 5MB/sec on the SCSI bus, 12% of the local bus bandwidth is used by transfers from the SCSI bus.RELIANCE S-D4007-E
3.產 品 展 示
4.公 司 優 勢 主 營 產 品
5.相 關 產 品 展 示
本篇文章出自瑞昌明盛自動化設備有限公司官網，轉載請附上此鏈接:http://www.fs-it.com.cn
