YASKAWA YPCT11077-1A繼電器模塊
1.產 品 詳 情 資 料：
裝回蓋子，將裝置安裝到DIN導軌上，然后重新連接電纜。8.重新建立電源后，檢查B（電池）LED是否亮起。9.以經批準的方式處理耗盡的鋰電池。SB822可充電外部電池單元鋰離子電池組件安裝在SB822單元內。為了防止出現問題，你需要定期充電。電池包規格：?類型：可充電鋰離子電池，3.75V 2.3 Ah?尺寸：Prismatic 14.5x43x50 mm?鋰當量：0.8 g更換SB822可充電外部電池單元中的電池更換鋰離子電池：1。斷開TK821V020電纜連接器。2.斷開24V電源電纜連接器3。從DIN導軌上松開SB822裝置。4.在繼續操作之前，將正確接地的ESD腕帶連接到手腕上。5.小心地拆下SB822單元蓋并識別電池包。6.小心地從PCB上斷開電池連接器。7.小心地拆下電池組。8.插入新電池并連接。重新組裝與拆卸相反。9.安裝裝置。10.以認可的方式處理磨損的電池包。
Replace the cover, mount the unit onto the DIN rail, and reconnect the cable. 8. When power is re-established, check that the B(attery) LED lights up. 9. Dispose of the run-down Lithium battery in an approved manner.SB822 Rechargeable External Battery Unit The Li-Ion battery package is mounted inside the SB822 unit. To prevent problems you need to charge it on a regular basis. Specification for the battery package: ? Type: Rechargeable Lithium-Ion, 3.75V 2.3 Ah ? Size: Prismatic 14.5x43x50 mm ? Lithium equivalent content: 0.8 g Replacing the Battery in an SB822 Rechargable External Battery Unit To replace the Li-Ion battery: 1. Disconnect the TK821V020 cable connector. 2. Disconnect the 24V supply cable connector 3. Release the SB822 unit from the DIN-rail. 4. Attach a properly grounded ESD wrist strap to your wrist before you proceed. 5. Carefully remove the SB822 unit cover and identify the battery package. 6. Carefully disconnect the battery connector from the PCB. 7. Carefully remove the battery package. 8. Insert the new battery and connect. Reassemble is reverse from disassemble. 9. Install the unit. 10. Dispose of the worn battery package in an approved manner.
2.產 品 展 示
3.公 司 優 勢 主 營 產 品
4.相 關 產 品 展 示
本篇文章出自瑞昌明盛自動化設備有限公司官網，轉載請附上此鏈接:http://www.fs-it.com.cn
